Support

The is a cranking or a folding support, which can be attached under the trailer. To each support we provide you a crank.

One and two of these crank/folding supports can be installed both at the nose or tail of the trailer

A support is most meaningful in the tail range. All loads, which develop when rigging at the tail of the trailer, wether it is caused by the airplane or by the person, who assembles the airplane, can be catched by it. Furthermore this support is actually essential with wind and storm-safe parking. Only by an additional support in the tail the trailer gets the entire stability, the fact that it won't turn around or even takes off (everything already occurred).

Also in front a support can be senseful to relieve the front wheel. More meaningfully however is to place two supports in the front range of the trailer, one on the left and one on the right. On the one hand both supports can be screwed comfortably in in this position, on the other hand the entire chassis is additionally stabilized. Possible swinging movements of the lift top while you montage are kept smaller with that way.

You have to decide, if a second rear support is meaningful or not. If your trailer is standing several months at the same place and you move it only rarely, a second rear support (then probably at the same time the fourth support) could be useful.

A support installed at the tail

A support installed at the tail