Product Description

" single-seater - trailers "

Drawings not true to scale, all measurements in mm

All trailers are prepared for 100 km/h permission.
If you should wish more detailed information, please contact us.

Lift top

• Fiberglass/Epoxy sandwich top with the following structure
  • outer side 2x400
  • inner side 1x400
  • in between a core of 3mm Coromat
  • in the rear reinforced by frames (stringer)
• good isolation
• nearly no condensation
• high twisting rigidity
• stable rotation point in the front
• high pressure gas springs on both sides
• big openangle of the lift top (168cm)
• Lacquer finish
  • outside: Gelcoat (white)
  • inside: Topcoat (grey-black-speckled, similarly LS cockpit)
• Front hatch
• Ramming protection profile
• Excenter lockers

Electrical equipment

• Elektric installation material made by"Hella"
• inside shifts ("under finery")
• 2 tail lamps (brake, light, turn signal)
• 1 licence plate light
• 1 fog tail light
• 2 triangle reflectors
• 6 side lights
• 1 distributor box
• 1 car plug, alternatively 7 or 13-pins

Bottom

• Aluminuim-construction
• Chassis side
  • double walled aluminium extrusions
  • integrated lateral guides for the wing dollies
• Tail gate
• Wear tail
• riveted soil made of special plywood plates 6mm (for motor- or turbo gliders 9mm)
• high quality varnish on the outer chassis sides (white or grey)
• Mudguards out of galvanized steel sheets

Chassis / Hauling equipment

• We use products of the following companies: KNOTT / WAP / BPW / ALKO
• Axle
• automatic back-up brakes
• front wheel (centered)
• back driving mechanism
• Tyre 195-65 on 51/2-15CH
• Hauling euipment (V-Pole)
• Hauling equipment (trailer coupling)
• Spare wheel hosted in the trailer
• Brake wedges mounted at the chassis sides

The following achievements are only with the complete package in the scope of supply. Customers, who order our trailers as a kit, receive the development set in addition and have to install the following parts in their own contribution.

Installations

• Spare wheel
• Spare wheel holder out of ALU
• Ramp with two jacks
• Aluminium guide rail profiles for the fuselage dolly and the wing dollies
• Ramp holder at the tail gate for the case of transportation
• Ramp holder in the front for the case of transportation
• Ramp holder in the tail for the case of rigging
• Fuselage dolly (GRP), padded, with ALU-Axle addapted for your airplane
• Fuselage nose holder (GRP), padded, with ALU-linkage addapted for your airplane
• Tail case (GRP) let in the soil and adapted for your airplane
• Wing dolly, completely installed, adjustable for each airplane but adjusted for your airplane
• Wing dolly fixings for the empty transportation of your trailer mounted at the side chassis
• Wing holding frame in the front for the admission of the mounting plates
• Wing mounting plates, front, ALU, padded, adjustable for each airplane but adjusted for your airplane
• Wing mounting plates, rear, ALU, padded, adjustable for each airplane but adjusted for your airplane
• Wing bed, (GRP), padded, adjustable for each airplane but adjusted for your airplane
• Elevator mounting plates mounted in the lift top, padded, adapted for your airplane
• all the construction units made out of aluminium or GRP
• Padding of all critical scrubbing and/or danger places
• 2 grasps in the front
• 2 grasps in the backl
• 1 lock for the front hatch
• 1 lock for the tail gate / lift top